Ranger 4WD L4-153 2.5L SOHC VIN C SFI (2001)
Coolant Line/Hose: Service and Repair
Water Pump-Inlet Tube
Removal
1. Drain the cooling system.
2. Raise and support the vehicle on a hoist.
3. Remove the lower radiator hose.
4. Disconnect the lower heater water hose from the water pump inlet tube.
5. Remove the bolts and the water pump inlet tube.
Installation
1. NOTE:
^
Reinstall the constant tension clamps in the same position from where they were removed.
^
Use long-life grease to lubricate the O-ring seal.
To install, reverse the removal procedure.