Ranger 4WD L4-153 2.5L SOHC VIN C SFI (2001)
Ignition Cable: Service and Repair
Spark Plug Wire Remover
SPECIAL TOOL(S)
REMOVAL
1. Use the Spark Plug Wire Remover to pull the spark plug wire off the spark plug.
NOTE: Do not pull on the spark plug wire set.
2. Squeeze the locking tabs and remove the spark plug wires from the ignition coil.
NOTE: Pull upward with a gentle side to side motion when removing the spark plug wires.
3. Disconnect the spark plug wire routing clips and remove spark plug wires.
INSTALLATION
1. Follow the removal procedure in reverse order.