Ranger 4WD L4-153 2.5L SOHC VIN C SFI (2001)
Installation
1. CAUTION: Make sure the parking lever actuating rod is correctly seated into the case parking rod guide cup. Verify that the output shaft is
locked in the PARK position.
Align the flats of the manual valve inner lever with the flats on the manual control lever shaft. Install the manual valve inner lever and parking
lever actuating rod onto the manual control lever shaft.
2. CAUTION: Do not bend the manual valve inner lever pin.
Install the manual valve inner lever nut.
3. Install the manual valve detent spring.
4. Clean the extension housing and install new extension housing gasket. Make sure that the parking pawl, spring, and shaft is correctly installed.
