Ranger 4WD L4-153 2.5L SOHC VIN C SFI (2001)
4. Using the Extension Housing Seal Replacer, install the extension housing seal.
5. NOTE: Inspect the driveshaft slip-yoke for wear and damage. Install new if required.
Align the drive shaft with the marks made during removal to ensure correct balance.
6. Install the rear driveshaft bolts.
7. Lower the vehicle.
8. Fill the transmission to the correct fluid level and check for correct transmission operation.
^
Use MERCON V Automatic Transmission Fluid XT-5-QM or equivalent meeting MERCON V specification.