Ranger 4WD L4-153 2.5L SOHC VIN C SFI (2001)
Transmission Mount: Service and Repair
Transmission Insulator and Retainer
Removal
1. NOTE: 4x2 procedure shown. 4x4 similar, front drive shaft will need to be removed.
Disconnect the battery ground cable.
2. Raise and support the vehicle.
3. NOTE: To maintain initial driveshaft balance, mark the rear driveshaft yoke and axle flange so they may be installed in their original alignment.
Mark the rear driveshaft.
4. Remove the rear driveshaft.
1. Remove the bolts.
2. Remove the rear driveshaft.
5. Remove the transmission mount nuts.
