Ranger 4WD L4-153 2.5L SOHC VIN C SFI (2001)
Clutch Slave Cylinder: Service and Repair
SLAVE CYLINDER
Removal
1. Remove the transmission.
2. NOTE: Inspect the clutch housing for traces of fluid. If brake fluid is visible, install a new clutch slave cylinder.
Remove the clutch slave cylinder.
1. Remove the bolts.
2. Remove the clutch slave cylinder.
3. Inspect the clutch slave cylinder for the following:
^
Worn or damaged boot
^
Leaking fluid.
^
Worn or damaged bearing.
4. Inspect the clutch release bearing as follows:
^
Rotate the outer race while applying pressure. If the bearing rotation is rough, install a new clutch slave cylinder.
^
Inspect for wear or damage.
^
If wear pattern is continuous (not segmented) and the wear appears to be deep in bearing face, install a new clutch slave cylinder.
Installation
1. To install, reverse the removal procedure.
^
Position the clutch slave cylinder to the transmission and install the bolts.
2. Install the transmission.
3. Bleed the clutch hydraulic system.
