Ranger 4WD L4-153 2.5L SOHC VIN C SFI (2001)
Using the special tool, hold the pinion flange and tighten the pinion nut.
^
Rotate the pinion occasionally to make sure the cone and roller bearings are seating correctly.
^
Install a Nm (inch-pound) torque wrench on the pinion nut.
^
Rotating the pinion through several revolutions, take frequent cone and roller bearing torque preload readings until the original recorded
preload reading is obtained.
^
If the original recorded preload is lower than specifications, tighten to the appropriate specifications for used bearings. If the preload is higher
than specification, tighten the nut to the original reading as recorded.
21. Install differential case in the rear axle housing.
22. Install the axle shafts.
23. Position the driveshaft and align the marks on the pinion flange.
24. CAUTION: The driveshaft centering socket yoke fits tightly on the rear axle pinion flange pilot. To make sure that the yoke seats squarely on the
flange, tighten the bolts evenly in a cross pattern as shown.
Install the driveshaft bolts.