Ranger 4WD L4-153 2.5L SOHC VIN C SFI (2001)
12. CAUTION: Install the halfshaft with a new hub nut and washer assembly.
CAUTION: Do not use power or impact tools to tighten the hub nut and washer assembly.
CAUTION: Install a new retainer circlip in the groove in the LH inboard CV joint housing stub shaft before installing the halfshaft in the vehicle.
To prevent the new retainer circlip from over-expanding when installing it, start one end in the groove and work the circlip over the shaft and into
the groove.
To install, reverse the removal procedure.
Disassembly and Assembly
DISASSEMBLY AND ASSEMBLY
Halfshaft
Special Tool(s)
Disassembly
1. Remove the front wheel halfshaft.
2. CAUTION: Do not damage the halfshaft boot. Remove the two inboard boot clamps.
