Ranger 4WD L4-2.3L VIN D (2002)
Parking Brake Cable: Service and Repair
Cable and Conduit - Rear
Cable and Conduit- Rear
Removal and Installation
1. NOTE: Make sure the parking brake control is fully released.
Relieve the tension on the' parking brake system.
1. Pull down on the front parking brake cable and conduit.
2. Insert a 4 mm (5/32-inch) drill bit or equivalent retainer.
2. Remove the drum brake shoes.
3. NOTE: Disconnect the parking brake intermediate cable from the locating hole end of the connector.
Disconnect the parking brake intermediate cable from the LH parking brake rear cable and conduit.