Ranger 4WD L4-2.3L VIN D (2002)
Engine Block Heater: Service and Repair
Block Heater
Removal
1. Drain the cooling system.
2. Raise and support the vehicle.
3. NOTE: 2.3L block heater is the screw in type.
Disconnect the connector.
4. Remove the block heater.
1. NOTE: Do not loosen the screw more than necessary for removal. Loosen the screw.
2. Twist and slide the block heater to release the retainer clip and discard the retainer clip.
3. Remove the block heater.
Installation
1. To install, reverse the removal procedure.