Ranger 4WD L4-2.3L VIN D (2002)
9. NOTE: This step is needed only if a new front cover is being installed.
Using a three jaw puller, remove the fan drive pulley.
10. CAUTION: There is one bolt behind the cooling fan drive pulley. This bolt can be accessed by lining up one of the holes in the pulley with the
bolt.
Remove the bolts and the engine front cover.
Installation
1. NOTE: This step is needed only if a new front cover is being installed.
Install the fan drive pulley, using a nut and bolt with flat washers.
2. CAUTION: Do not use metal scrapers, wire brushes, power abrasive disks or other abrasive means to clean sealing surfaces. These tools cause
scratches and gouges which make leak paths.