Ranger 4WD L4-2.3L VIN D (2002)
5. Position the power steering pump and install the lower retaining bolt.
6. Connect the Power Steering Pressure (PSP) switch electrical connector.
7. Install the water pump pulley.
8. Install the belt tensioner.
9. Install the crankshaft pulley. See: Cylinder Block Assembly/Harmonic Balancer - Crankshaft Pulley/Service and Repair
10. NOTICE: Only hand tighten the 6 mm (0.23 in) bolt or damage to the front cover can occur.
Install a 6 mm x 18 mm bolt through the crankshaft pulley and thread it into the front cover.