Ranger 4WD L4-2.3L VIN D (2002)
7. NOTE: If equipped, the transmission servo heat shield needs to be unclipped from the fluid pan rail and positioned out of the way for fluid pan
removal.
Loosen the nut and position the heat shield out of the way.
8. Remove the front band locknut and unscrew the front band adjusting screw.
-
Discard the front band locknut after removal.
9. CAUTION: The servo cover is under spring pressure.
Using the special tool, remove the front band servo cover retaining ring.
-
Slowly remove tension on the J-hook nut and remove the servo cover compressor.
10. CAUTION: The special tool should be used to prevent damage to servo and bore.
Using the special tool, remove the front band servo cover, servo piston and servo piston spring.
-
Insert the special tool into the transmission case, locate on servo rod, and remove the front band servo cover, servo piston and servo piston
spring.
Installation