Ranger 4WD L4-2.3L VIN D (2002)
Differential Axle Housing: Service and Repair
Rear Drive Axle/Differential-Ford 7.5-Inch Ring Gear
Axle Housing
Removal
1. Remove the axle shafts.
2. Mark the driveshaft flange and pinion flange for correct alignment during installation.
3. Remove the four driveshaft bolts.
4. CAUTION: The driveshaft centering socket yoke is tightly on the rear axle pinion flange pilot. Never hammer on the driveshaft or any of its
components to disconnect the yoke from the flange. Pry only in the area shown with a suitable tool to disconnect the yoke from the flange.
Using a suitable tool as shown, disconnect the driveshaft centering socket yoke from the rear axle pinion flange.
-
Position the driveshaft aside.
5. Disconnect the rear brake anti-lock sensor electrical connector and wiring harness clips.