Ranger 4WD L4-2.3L VIN D (2002)
12. Rotate the differential assembly several times to verify that the differential bearings seated correctly.
13. Using the special tools, recheck the backlash.
-
If backlash is within the specification, refer to Backlash within specification. If backlash is not within the specification, repeat Backlash not
within specification.
-
The specification shown is the full allowable range.
Backlash within specification
14. Remove the bolts and the bearing caps.
15. To establish differential bearing preload, increase both left and right differential bearing shim sizes by the specification shown.
16. Using the special tool, fully seat the differential bearing shims. Make sure the assembly rotates freely.
