Ranger 4WD L4-2.3L VIN D (2002)
4. CAUTION: The driveshaft flange fits tightly on the rear axle pinion flange pilot. Never hammer on the driveshaft or any of its components to
disconnect the driveshaft flange from the pinion flange. Pry only in the area shown with a suitable tool to disconnect the driveshaft flange from the
pinion flange.
Using a suitable tool as shown, disconnect the driveshaft flange from the rear axle pinion flange.
5. Install a Nm (inch-pound) torque wrench on the nut and record the torque necessary to maintain rotation of the pinion through several revolutions.
6. CAUTION: Discard the nut after removing it. Install a new nut during installation.
Use the special tool to hold the pinion flange while removing the nut.
7. Index-mark the pinion flange and the drive pinion stem for correct alignment during installation.