Ranger 4WD L4-2.3L VIN D (2002)
3. Install the four differential side bearing cap bolts.
10. NOTE: Drive pinion bearing adjustment shims must be flat and clean.
NOTE: A slight drag should be felt for correct shim selection. Do not attempt to force the pinion shim between the gauge block and the gauge
tube. This will minimize selection of a pinion shim thicker than required, which results in a deep tooth contact in final assembly of integral rear
axle assemblies.
Use a drive pinion bearing adjustment shim as a gauge for shim selection.
-
After the correct shim thickness has been determined, remove the special tools.
11. Using the special tool, press the pinion bearing until it is firmly seated on the pinion and pinion shim.
12. Place a new drive pinion collapsible spacer on the pinion shaft against the pinion stem shoulder.
13. CAUTION: Installation without the correct tool can result in early seal failure. If the rear axle drive pinion seal becomes cocked during
installation, remove it and install a new one.