Ranger 4WD L4-2.3L VIN D (2002)
8. NOTE: This step duplicates final pinion bearing preload.
Tighten the special tool to the specification shown.
9. NOTE: Offset the special tool to obtain an accurate reading.
Rotate the special tool several half-turns to make sure the pinion bearings seat correctly and position the special tool as shown.
10. Install the special tool.
1. Position the special tool.
2. Install the beating caps.
3. Install the bolts.
11. CAUTION: Use only flat, clean drive pinion bearing adjustment shims.
CAUTION: Selection of too thick a shim results in a deep tooth contact at final assembly. Do not attempt to force the shim between the special