Clutch Slave Cylinder to Clutch Master Cylinder Tube Replacement
Clutch Slave Cylinder: Service and Repair
Clutch Slave Cylinder to Clutch Master Cylinder Tube
REMOVAL
1. Raise vehicle on a hoist and position suitable safety stands under vehicle.
Clutch Coupling Tool T88T-70522-A
2. Depress the white retainer bushing with T88T-70522-A, or equivalent, while pulling on the line.
INSTALLATION
1. Push the male connector onto the female connector of the clutch slave cylinder.
NOTE: Minimal loss of fluid should occur during removal and installation, and bleeding should not normally be required unless the vehicle
shows signs of lack of clutch reserve.
2. Remove the safety stands and lower the vehicle.