Ranger 4WD V6-182 3.0L (1994)
See: Powertrain Management/Computers and Control Systems/Testing and Inspection/Pinpoint Tests/NA - Ignition Diagnostic Monitor --
Distributor Ignition/NA1 - Erratic Ignition
DTC 212
Loss of ignition diagnostic monitor input to powertrain control module or spark output circuit grounded.
KOEO Memory Code ............................................................................................................................................................................... Go to NA2
See: Powertrain Management/Computers and Control Systems/Testing and Inspection/Pinpoint Tests/NA - Ignition Diagnostic Monitor --
Distributor Ignition/NA2 - Check IDM Circuit Continuity
DTC 213
Spark output circuit open.
KOER Hard Code ..................................................................................................................................................................................... Go to PA1
See: Powertrain Management/Computers and Control Systems/Testing and Inspection/Pinpoint Tests/PA - Spark Timing Check -- Distributor
Ignition/PA1 - Check For Power to PCM
DTC 214
Cylinder identification circuit failure.
KOEO Memory Code ............................................................................................................................................................................... Go to DR1
See: Powertrain Management/Computers and Control Systems/Testing and Inspection/Pinpoint Tests/DR - Cylinder Identification (CID)
Sensor/DR1 - Will Engine Start
DTC 215
Powertrain control module detected coil 1 primary circuit failure.
KOEO Memory Code - Go to Ignition System / Testing and Inspection.
DTC 216
Powertrain control module detected coil 2 primary circuit failure.
KOEO Memory Code - Go to Ignition System / Testing and Inspection.
DTC 217
Powertrain control module detected coil 3 primary circuit failure.
KOEO Memory Code - Go to Ignition System / Testing and Inspection.
DTC 218
Loss of ignition diagnostic monitor signal-left side.
KOEO Memory Code - Go to Ignition System / Testing and Inspection.
DTC 219
Spark timing defaulted to 10 degrees, spark output circuit open.
KOEO Memory Code - Go to Ignition System / Testing and Inspection.
