Ranger 4WD V6-182 3.0L (1994)
Circuit Breaker: Testing and Inspection
NOTE: The 6 amp circuit breaker is located in the fuse panel. Two separate tests are necessary to check the circuit breaker for proper operation. Before
performing these tests, remove the circuit breaker from the fuse panel and connect the tester leads to the circuit breaker.
Test 1
1. Short tester leads together and adjust current draw until it equals circuit breaker rating.
2. Connect circuit breaker to tester.
3. Leave circuit breaker connected to tester for 10 minutes, holding current reading on tester at rated current. If circuit breaker opens before 10
minutes have elapsed, replace circuit breaker.
Test 2
1. Short tester leads together and adjust current draw until it is twice the rated current.
2. Connect circuit breaker to tester, holding current reading on tester at twice the rated current.
3. If tester reading does not drop to zero within 30 seconds, replace circuit breaker.
