Ranger 4WD V6-183 3.0L (1993)
7.
Release master cylinder pushrod.
8.
Fill reservoir.
9.
Repeat Steps 4 through 8 four more times.
10.
With the master cylinder still being held with the outlet tube and reservoir feed tube ends high, quick-connect closed and the reservoir full, proceed
as follows:
a.
Push the pushrod into the body several times quickly to expel any remaining air.
b.
If it is a remote reservoir, pinch the supply hose with your fingers two or three times to help move air into reservoir.
11.
When the movement of the pushrod is .1601, (4 mm) or less when stroked in Step 10, reinstall the master cylinder into the vehicle and couple it to
the slave cylinder per 1993 Ranger Service Manual Procedure, Page 08-02-03.
Final Inspection
1.
Confirm that the audible growl is no longer present.
2.
Inspect the vehicle for leaks and proper clutch operation.
^
If the hydraulic system leaks, check for a missing O-ring and any loose connections at either end of the hydraulic line.
^
If the clutch pedal feels effortless, actuate the clutch pedal several times at full stroke.
^
If the pedal still feels effortless, then the hydraulic system is probably not fully bled. Therefore, rebleed the hydraulic system.
