Ranger 4WD V6-245 4.0L VIN X SFI (1999)
Throttle Position Sensor: Service and Repair
REMOVAL
1. Disconnect the battery ground cable.
2. Disconnect the Throttle Position sensor (TP) connector.
3. Remove the screws and the throttle position sensor
INSTALLATION
1. To install, reverse the removal procedure.
NOTE: Failure to install the throttle position sensor in this manner may result in excessive idle speeds. Install the throttle position sensor by
sliding the rotary tangs into position over the throttle shaft blade, then rotate the throttle position sensor.
2. Install the throttle position sensor with the tangs in proper alignment.