Ranger 4WD V6-245 4.0L VIN X SFI (1999)
14. Remove the guide pins from. main control valve body.
1
Remove large guide pin.
2
Remove small guide pin.
15. Rotate the main control valve body so the valve body separator plate is facing down.
16. CAUTION: All solenoid electrical connectors must face upward on installation.
NOTE: All shift solenoids are interchangeable.
NOTE: If the TCC valve came out during disassembly, use caution when installing the torque converter clutch solenoid.
Install the SSB, SSD, TCC and EPC solenoids.
1
Install the TCC solenoid.
2
Install the SSB and SSD solenoids.
3
Install the EPC solenoid.
17. CAUTION: The solenoid clamp must be installed in the TCC and EPC solenoid grooves, shift solenoid pockets and the No. 204 plug.
Install the solenoid clamp and the screw.
1
Position the solenoid clamp on the main control valve body.
2
Install the screw.