Ranger 4WD V6-245 4.0L VIN X SFI (1999)
5. Remove the front anti-lock brake sensor.
1
Remove the bolt.
2
Remove the front anti-lock brake sensor.
Installation
1. NOTE: Plug the sensor mount opening and thoroughly clean the mounting surface. Apply High Temperature 4x4 Front Axle and Wheel Bearing
Grease E8TZ-19590-A meeting Ford Specification ESA-M1C198-A.
To install, reverse the removal procedure.
Rear
Removal
1. Raise and support vehicle.
2. NOTE: Clean off dirt and debris that may have collected around the rear anti-lock brake sensor before removal.
Remove the rear anti-lock brake sensor.
1
Disconnect the rear anti-lock brake sensor electrical connector.
2
Remove the bolt.
3
Remove the rear anti-lock brake sensor.
Installation