Ranger 4WD V6-245 4.0L VIN X SFI (1999)
4. Remove the ignition switch lock cylinder.
-
Use a 1/8-inch diameter drill bit to drill out the lock cylinder retaining pin.
-
Use a 3/8-inch diameter drill to drill down the middle of the ignition lock key slot until the ignition switch lock cylinder breaks loose.
-
Remove and discard the ignition switch lock cylinder and drill shavings from the steering column.
5. Remove the bearing retainer.
6. Remove the bearing and the gear.
-
Thoroughly clean all drill shavings from the steering column and inspect it for damage.
Installation