Ranger 4WD V6-245 4.0L VIN X SFI (1999)
1
Remove the transmission mount-to-extension housing screws.
2
Remove the transmission mount.
9. Remove the six extension housing screws and studs.
10. NOTE: The parking pawl, parking pawl return spring and parking pawl shaft may fall out during removal of the extension housing.
Remove the extension housing. Discard the extension housing gasket.
Installation
1. Clean the extension housing and install a new extension housing gasket. Make sure that the parking pawl, spring, and shaft are correctly installed.
2. CAUTION: Make sure the parking lever actuating rod is correctly seated into the case parking rod guide cup.
Install the extension housing.