Ranger 4WD V6-245 4.0L VIN X SFI (1999)
14.
Apply a continuous bead of silicone rubber RTV (included in the kit) to the new cover sealing surface.
15.
Install the new cover to the axle housing. Install the new vent hose and clip from the kit to the cover (Figure 1). Tighten all bolts to 20-25 lb-ft
(27-34 N.m).
16.
Connect the new vent hose to the existing vent hose using the in-line connector supplied in the kit (Figure 1).
17.
Remove the old vent from the axle assembly and install the pipe plug supplied in the kit.
18.
Raise the axle into position and install the axle support bushing bolts and NEW nuts. Torque the bolts to 49 lb-ft (66 N.m).
19.
Install the axle support-mounting bracket to the axle housing. Torque the bolts to 78 lb-ft (106 N.m).
20.
Install the driveshaft using new bolts. Torque to 14 lb-ft (19 N.m).
21.
Remove axle housing fill plug and fill with 3.25 pints (1.54 L) of Motorcraft SAE 80W-90 Premium Rear Axle Lubricant. Install fill plug.
Parts Block
WARRANTY STATUS: Eligible Under Provisions Of New Vehicle Limited Warranty Coverage
OPERATION
DESCRIPTION
TIME
050620A
1995-2001 Explorer
1.5 Hrs.
1997-2001 Mountaineer
1997-2005 Ranger
2001-2003 Explorer Sport
2001-2005 Explorer Sport
Trac: Install A Revised
Axle Cover Kit
DEALER CODING
CONDITION
BASIC PART NO.
CODE
4022
D1