Ranger 4WD V6-245 4.0L VIN X SFI (1999)
8. NOTE: The special tool must be offset to obtain an accurate reading.
Rotate the special tool several half-turns to ensure correct seating of the pinion bearings and position the special tool.
9. Install the special tool.
1
Position the special tool.
2
Install the differential side bearing caps.
3
Install the four differential side bearing cap bolts.
10. NOTE: Drive pinion bearing adjustment shims must be flat and clean.
NOTE: A slight drag should be felt for correct shim selection. Do not attempt to force the pinion shim between the Gauge Block and the Gauge
Tube. This will minimize selection of a pinion shim thicker than required, which results in a deep tooth contact in final assembly of integral rear
axle assemblies.
Use a drive pinion bearing adjustment shim as a gauge for shim selection.
^
After the correct shim thickness has been determined, remove the special tools.