Ranger 4WD V6-245 4.0L VIN X SFI (1999)
6. Remove the driveshaft flange yoke.
1
Position the driveshaft flange yoke in the U-Joint Tool.
2
Press out a bearing cup.
3
Remove the driveshaft flange yoke.
4
Press on the spider to remove the remaining bearing cup.
5
Remove the driveshaft flange yoke.
7. Remove the spider.
1
Reposition the driveshaft in the U-Joint Tool.
2
Press out the bearing cup.
3
Rotate the driveshaft.
4
Press on the spider to remove the remaining bearing cup.
5
Remove the spider.
8. Clean the yoke area at the end of the driveshaft.
Assembly
1. NOTE: Universal joint kits are to be installed as complete assemblies only. Do not mix components from other U-joint kits.
Install the spider.
1
Start a new bearing cup into the driveshaft yoke.
^
Check the needle bearings for correct positioning.
2
Position the new spider in the driveshaft yoke.
3
Position the driveshaft in the U-Joint Tool.
4
Press the bearing cup to just below the snap ring groove.
^
Repeat for the other bearing cup.
2. Inspect the driveshaft flange yoke. Install new if necessary.