Ranger 4WD V6-3.0L (2008)
3. NOTE: After disconnecting the hydraulic control unit (HCU) brake tube fittings, cap the holes in the HCU to prevent contamination or foreign
material from entering the brake tube ports.
Disconnect the 5 HCU brake tube fittings from the HCU.
^
To install, tighten to 17 Nm (13 lb-ft).
4. Remove the 2 HCU-to-bracket nuts and the HCU assembly.
^
To install, tighten to 5 Nm (44 lb-inch).
5. If necessary, remove the 2 HCU bracket-to-frame nuts, the 2 HCU bracket-to-frame bolts and the HCU bracket.
^
To install, tighten to 12 Nm (9 lb-ft).
6. To install, reverse the removal procedure.
7. Bleed the brake system.
