Ranger 4WD V6-3.0L (2008)
Wheel Speed Sensor: Service and Repair
Wheel Speed Sensor - Rear
Wheel Speed Sensor - Rear
Removal and Installation
1. With the vehicle in NEUTRAL, position it on a hoist.
2. Disconnect the wheel speed sensor electrical connector.
3. Remove the wheel speed sensor bolt and the wheel speed sensor.
^
To install, tighten to 27 Nm (20 lb-ft).
4. NOTE: Plug the sensor cavity and thoroughly clean the sensor mounting surface.
NOTE: Inspect the anti-lock brake sensor O-ring seal for damage; lightly lubricate the O-ring seal with the specified lubricant.
To install, reverse the removal procedure.