Ranger 4WD V6-3.0L (2008)
Air Bag Deactivation Indicator: Service and Repair
PASSENGER AIR BAG DEACTIVATION (PAD) INDICATOR
Removal and Installation
NOTE:
-
The air bag warning indicator illuminates when the restraints control module (RCM) fuse is removed and the ignition switch is ON. This is normal
operation and does not indicate a supplemental restraint system (SRS) fault.
-
Repair is made by installing a new part only. If the new part does not correct the condition, install the original part and carry out the diagnostic
procedure again.
-
The SRS must be fully operational and free of faults before releasing the vehicle to the customer.
1. Depower the SRS.
2. Remove the 2 instrument panel (I/P) center finish panel screws.
3. Pull out to detach the 4 retaining clips and partially remove the I/P center trim panel.
4. Disconnect the passenger air bag deactivation (PAD) indicator electrical connector.
5. Remove the 2 screws from the PAD indicator and remove it from the I/P center finish panel.
6. To install, reverse the removal procedure.
7. Repower the SRS.
