Ranger 4WD V6-3.0L (2008)
15. Move the LH inner tie rod forward to clear the frame crossmember.
16. Remove the steering gear.
Installation
All vehicles
1. CAUTION: Handle the steering gear with caution to avoid damage to fluid transfer tubes and to avoid dimples in the steering gear
bellows boot.
NOTE: Make sure the steering gear input shaft is turned to the left until the stop is reached.
Turn the steering gear input shaft to the right until the stop is reached. Count and record the number of turns required.
2. NOTE: Make sure the steering gear control valve housing is turned toward the front of the vehicle.
Install the steering gear into the RH opening of the crossmember.
