Ranger 4WD V6-3.0L (2008)
Control Arm: Service and Repair
Lower Arm - Coil Spring Suspension
Lower Arm - Coil Spring Suspension
Lower Arm - Coil Spring Suspension
Removal and Installation
CAUTION: Suspension fasteners are critical parts because they affect performance of vital components and systems and their failure may
result in major service expense. New parts must be installed with the same part number or an equivalent part if replacement is necessary. Do
not use a replacement part of lesser quality or substitute design. Torque values must be used as specified during reassembly to make sure of
correct retention of these parts.
1. Remove the spring.
2. Remove and discard the 2 lower arm bolts, flag nuts and the lower control arm.
^
To install, tighten to 200 Nm (148 lb-ft).
3. If necessary, replace the jounce bumper and jounce bumper nut.
^
To install, tighten to 25 Nm (18 lb-ft).
4. To install, reverse the removal procedure.
^
Check and, if necessary, align the front end.
