Ranger 4WD V6-3.0L (2008)
-
To install, tighten to 9 Nm (80 lb-in).
3. Remove the RH and LH windshield wiper pivot arms.
1
Pull up on the pivot arm.
2
Pull out on the retainer tab.
4. Position the PCM connector and harness aside.
1
Loosen the bolt.
2
Remove the nut and stud.
-
Disconnect the PCM electrical connector and position the harness aside.
5. Remove the RH access cover.
1
Remove the screws.
2
Remove the access cover.
6. Position the power distribution box aside and remove the LH access cover.
1
Remove the screws.
2
Remove the access cover.
