Ranger 4WD V6-3.0L VIN U (1997)
Measuring Brake Drum
6. Set the a brake adjustment gauge to the inside diameter of the drum braking surface.
Measuring Rear Brake Shoe And Lining
7. Reverse the tool as shown and adjust the rear brake shoe and lining until they match the gauge setting. The gauge contact points on the rear brake
shoe and lining must be parallel to the vehicle with the center line through the center of the axle.
8. Hold the brake shoe adjusting lever out of engagement while rotating the notched part of the adjuster screw assembly, to prevent burring the
notches. Make sure the adjuster rotates freely.
9. If necessary, remove the adjuster for disassembly and cleaning, then lubricate the adjusting screw threads and pilot end with a thin, uniform
coating of Disc Brake Caliper Slide Grease D7AZ-19590-A or equivalent meeting Ford specification ESA-M1C172-A.
10. Install the brake drums.
11. Install the wheel on the brake drum and tighten the lug nuts to 135 N.m (100 ft. lbs.). Remove the safety stands and lower the vehicle.
12. After adjusting the brake shoes, check brake operation before moving the vehicle.
13. Complete the adjustment by sharply applying the brakes several times while driving the vehicle alternately in forward and reverse.