Ranger 4WD V6-3.0L VIN U (1997)
Adjuster Cable Anchor Fitting
5. Install the brake shoe anchor pin guide plate. Place the brake shoe adjusting lever cable anchor over the anchor pin with the crimped side away
from the brake backing plate.
Brake Shoe Retracting Spring
6. Install the primary shoe-to-anchor (short) spring using a brake spring removal/installation tool.
7. Install the cable guide on the secondary shoe web with the flanged holes fitted into the hole in the secondary shoe web. Thread the brake shoe
adjusting lever cable around the cable guide groove.
NOTE: Make sure the brake shoe adjusting lever cable is positioned in the groove, and not between the cable guide and the shoe web.
8. Install the secondary shoe-to-anchor (long) spring.
NOTE: Make sure the cable end is not cocked or binding on the anchor pin when installed. All parts should be flat on the anchor pin.
9. Remove the wheel cylinder clamp.