Ranger 4WD V6-3.0L VIN U (1997)
Backup Lamp Switch: Service and Repair
With 5-Speed Manual Transmission
REMOVAL
Backup Lamp Switch
1. Place the transmission in any position other than reverse or neutral and disconnect the backup lamp switch to rear lamp feed wire from the backup
lamp switch.
NOTE: The backup lamp switch is located on the shift cover left side.
2. Remove the backup lamp switch from the transmission.
INSTALLATION
For installation, follow removal procedures in reverse order. Tighten the new backup lamp switch to 11-16 Nm (8-12 Lb-Ft).