Ranger 4WD V6-3.0L VIN U (1997)
Ignition Coil: Service and Repair
Ignition Coil
Ignition Coil
REMOVAL
1. Disconnect fuel charging wiring electrical connectors from ignition coil and radio ignition interference capacitor.
CAUTION: Do not pull on the spark plug wire as it may separate from the spark plug wire connector inside the spark plug wire boot.
2. Disconnect spark plug wires by squeezing locking tabs and twisting while pulling upward.
3. Remove two ignition coil nuts and top ignition coil mounting bracket nut. Remove ignition coil and radio and ignition interference capacitor for
installation with the new ignition coil.
4. Remove Exhaust Gas Recirculation (EGR) vacuum regulator solenoid nuts and remove EGR vacuum regulator solenoid.