Ranger 4WD V6-3.0L VIN U (1997)
5. Remove instrument panel ash receptacle from instrument panel.
6. Remove the four ash receptacle bracket bolts, place ash receptacle bracket on floor and disconnect two PAD switch electrical connectors.
CAUTION: When removing ash receptacle bracket, be careful not to disconnect PAD switch electrical connector until ash receptacle bracket has
been placed on floor.
7. Remove the two PAD switch screws, lift PAD switch up from bottom and remove from ash receptacle bracket.
8. To install, reverse the removal procedure. Tighten ash receptacle bracket bolts to 2-3 Nm (18-26 lb ft).