Ranger 4WD V6-3.0L VIN U (1997)
Torque Converter: Flow of Diagnosis
Prior to torque converter replacement all diagnostic procedures must be followed. This is to prevent the unnecessary replacement of good torque
converters. Only after a complete diagnostic evaluation can the decision be made to replace the torque converter.
Begin with the normal diagnostic procedures as follows:
1. Preliminary inspection.
2. Know and understand the customer's concern.
3. Verify the concern.
^
Perform the Torque Converter Clutch Operation Test. See: Component Tests and General Diagnostics/Torque Converter Operation Test
4. Perform diagnostic procedures.
^
Run on-board diagnostics.
-
Repair all non-transmission related DTCs first.
-
Repair all transmission DTCs.
-
Rerun on-board diagnostic to verify repair.
^
Perform Line Pressure Test.
^
Perform Stall Speed Test.
^
Diagnosis by Symptom Routines.
-
Use the index to locate the appropriate routine that best describes the symptom(s). The routine will list all possible components that may
cause or contribute to the symptom. Check each component listed, diagnose and repair as required, before replacing the torque converter.
