Ranger 4WD V6-3.0L VIN U (1997)
INSTALLATION
1. Prior to installing the gearshift lever, lubricate the pivot bolt and bushing bore with Premium Long-Life Grease XG-1-C or -K or equivalent
meeting Ford specification ESA-M1C75-B.
2. Prior to installing the gearshift lever, move the transfer case lever to the 4L position.
3. Install gearshift lever to the extension housing with bolts turned to one turn loose. Install gearshift lever socket bushing to gearshift lever with fiat
facing out. Install lever to gearshift lever socket bushing and transfer case shift shaft. Tighten nut to 26-35 Nm (19-26 ft. lbs.).
4. Adjust the linkage. Always tighten the large bolt (A) retaining the shifter to the extension housing before tightening the small bolt (B).
5. Install the vent assembly so the white marking on the transfer case breather tube is in position in the notch in the shifter.
NOTE: The upper end of the transfer case breather tube should be 19 mm (3/4 inch) above the top of the shifter and positioned just below the
floor pan.
6. Install the gearshift lever boot and the floor pan cover.
7. Warm the gearshift lever knob with Rotunda Heat Gun 107-00300 or equivalent to 60-87° C (140-189° F) and tap the knob on the lever with a
7/16 socket and a mallet. Install the plastic shift pattern insert.
NOTE: The end of the gearshift lever knob should be to the end of the knurl on the upper portion of the shift lever.
8. Check the transfer case for proper shifting and operation.