Ranger 4WD V6-3.0L VIN V Flex Fuel (1999)
4. Remove the RCM with bracket.
1
Slide the RCM electrical connector locking clip to disengage it.
2
Disconnect the RCM electrical connector.
3
Remove the two bolts retaining the RCM bracket.
4
Remove the RCM with bracket.
INSTALLATION
1. Follow the removal procedure in reverse order.
WARNING: The tightening torque of the air bag restraint control module (RCM) bracket retaining bolts is critical for proper system
operation.
NOTE: A repair is made by installing a new part only. If the new part does not correct the condition, install the original part and perform the
diagnostic procedure again.
2. Prove out the air bag system.
