Ranger 4WD V6-3.0L VIN V Flex Fuel (1999)
Seat Belt Height Adjuster: Service and Repair
Shoulder Safety Belt Height Adjuster With Stripped Weld Nuts
D-Ring Installation Kit
Special Tool(s)
1. Remove the rear door trim panel.
2. Use the 1/2-inch drill provided in D-Ring installation Kit to drill out the damaged threads in the upper pillar structure.
3. Apply a suitable lubricant to the M14 x 1.5 tap provided in D-Ring installation Kit and tap new threads.
NOTE: After each rotation, back off tap slightly to remove new cuttings and be sure to blow out any chips before proceeding.
4. Use a threaded insert provided in D-Ring installation Kit and screw it into the retapped hole until it is slightly below the surface.