Ranger 4WD V6-3.0L VIN V Flex Fuel (1999)
6. Unclip main control valve body wire harness.
^
Lift up on wire harness guide and protector and disengage the retaining pins from the solenoid clamps.
7. Disconnect the six solenoid electrical connectors.
1
Disconnect the SSA, SSB, SSC and SSD electrical connectors.
2
Disconnect the Torque Converter Clutch (TCC) solenoid electrical connector.
3
Disconnect the Electronic Pressure Control (EPC) solenoid electrical connector.
8. Remove the manual control valve detent lever spring.
1
Remove the manual control valve detent lever spring screw.
2
Remove the manual control valve detent lever spring.
9. Remove the low/reverse servo.
1
Remove the low/reverse servo cover screws.
2
Remove the low/reverse band servo cover and gasket. Discard the low/reverse servo separator plate cover gasket.