Ranger 4WD V6-3.0L VIN V Flex Fuel (1999)
Apply a coating of Ford High Temperature Wheel Bearing Grease E8TZ- 19590-A meeting Ford specification ESA-M1C198-A to the axle main
seal prior to seating the axle shaft against the main seal.
8. CAUTION: Install the cotter pin into the lower ball joint from outboard to inboard. Failure to do so will cause damage to the wheel and
tire assembly.
Connect the front suspension lower arm to the front wheel knuckle.
1
Position the lower ball joint into the front wheel knuckle.
2
Install the castellated nut.
3
Install a new cotter pin.
9. Install the tie-rod end castellated nut.
1
Position the tie-rod end.
2
Install the castellated nut.
3
Install a new cotter pin.
10. Install the torsion bar.
11. Install the wheel hub.
12. Lower the vehicle.
13. Perform the wheel-end vacuum leak test.
14. Check the ride height.
15. Check the alignment.