Ranger 4WD V6-3.0L VIN V Flex Fuel (1999)
Band: Adjustments
Intermediate Band
1. Disconnect the battery ground cable.
2. Raise and support the vehicle.
3. Remove the shift cable.
1
Disconnect the shift cable from the manual control lever.
2
Remove the shift cable from the bracket.
4. Remove the digital Transmission Range (TR) sensor.
5. CAUTION: Do not allow the screw to back out. Band strut could fall out of position.
CAUTION: Throw the locknut away. The locknut is not reusable for assembly.
Remove and discard the locknut.
6. CAUTION: Install, but do not tighten, a new locknut on the screw. Apply petroleum jelly to the locknut seal.
CAUTION: The intermediate servo must be installed prior to band adjustment.
NOTE: The wrench will click at the specified torque. Install new lock nut, do not tighten at this time.
Tighten the screw using the Band Adjuster Wrench Kit and back off the screw exactly two (2) turns and hold that position.