Ranger 4WD V6-3.0L VIN V Flex Fuel (1999)
1. Position the special tool.
2. Install the differential side bearing caps.
3. Install the four differential side bearing cap bolts.
10. NOTE: Drive pinion bearing adjustment shims must be flat and clean.
NOTE: A slight drag should be felt for correct shim selection. Do not attempt to force the pinion shim between the gauge block and the gauge
tube. This will minimize selection of a pinion shim thicker than required, which results in a deep tooth contact in final assembly of integral rear
axle assemblies.
Use a drive pinion bearing adjustment shim as a gauge for shim selection. After the correct shim thickness has been determined, remove the
special tools.
11. Use a press and the special tool to press the pinion bearing until it is firmly seated on the pinion and pinion shim.
12. Place a new drive pinion collapsible spacer on the pinion shaft against the pinion stem shoulder.