Ranger 4WD V6-3.0L VIN V Flex Fuel (1999)
5. NOTE: If necessary, use a pair of pliers to remove a bearing cup if it cannot be pressed out all the way.
Remove the driveshaft slip-yoke.
1
Position the driveshaft slip-yoke in the U-Joint Tool.
2
Press out a bearing cup.
3
Rotate the driveshaft slip-yoke.
4
Press on the spider to remove the remaining bearing cup.
5
Remove the driveshaft slip-yoke.
6. Repeat Step 5 to remove the remaining bearing cups and spider from the driveshaft.
7. Clean the yoke area at each end of the driveshaft.
Assembly
1. NOTE: Universal Joint Service Kits are to be installed as complete assemblies only. Do not mix components from other U-Joint Kits.
Install the bearing cup.
1
Start a new bearing cup into the driveshaft yoke.
^
Check the needle bearings for correct positioning.
2
Position the new spider in the driveshaft yoke.
3
Using the U-Joint Tool, press the bearing cup to just below the snap ring groove.